Bodywork, interior and exterior trim and glass, bumpers, etc.
2 posts • Page 1 of 1
Hi all. My Estate recently failed its mot on a small hole near the ns rear subframe mount, after prodding its unsurprisingly far worse. Due to blown underseal the outer inner rear arch on both sides has holed strangely at its highest point along with the leading edge of the boot floor ,inner sills and rear wings under the bumper. Its touch and go as to whether its worth doing. As its all in very hard to reach areas. So does anyone have any inner arches ? I Don't mind ropey ones as its not the whole arch .boot floor bits would be great also. Devon based but don't mind a bit of a trip and happy to cut bits out of a scrapper.
Who is online
Users browsing this forum: No registered users and 1 guest