gearbox

Clutch, Gearbox, Overdrive, Propshaft, Differential, Drive Shafts, Hubs.
Post Reply
Message
Author
t2000
Groupie
Groupie
Posts: 84
Joined: Tue Oct 07, 2008 6:23 pm

gearbox

#1 Post by t2000 » Wed May 15, 2019 10:05 am

Hi just noticed a bad oil leak from j type overdrive gearbox rear seal has gone is it possible to do oil seal in situ? tia dave,

tony
Senior Member
Senior Member
Posts: 744
Joined: Sun Jun 14, 2009 5:35 am
Location: New Zealand

Re: gearbox

#2 Post by tony » Thu May 16, 2019 4:38 am

Not a big job. Drop the driveshaft, undo the big nut holding the driveshaft flange on and remove. hook the seal out and replace. Make sure the running surface on the flange is not too scored, clean it up with a bit of emery cloth.
If you have a nyloc nut probably best to replace it with new and retorque to the figure in the book.
Tony.
1976 2500 TC. converted to S specs.

Lots of bits

1999 BMW Z3.
2006 BMW 325ti.
Hopefully not needing too many bits.




.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest